Куплю запчасти, нужен ремонтПоиск запасных частей и расходки для полиграфического оборудования и вспомогательной техники. Запросы на ремонт и обслуживание промышленного полиграфического оборудования.
Если память меня не подводит, то у вас ошибка на последней секции на защите цилиндров. Там датчик слева есть под крышкой защиты, на нём огонёк должен загораться. Иногда датчик съезжает. Вроде так. (могу ошибаться, нет под рукой списка ошибок)
RYOBI 525GXlP, 526GX/P
The contact point of the safety circuit connection relay is connected
with the contact pOint of the back safety cover switch on each unit in
the safety circuit in parallel. During the RPC process the switch for
the unit selected will turn ON. When the back safety cover is opened
during the RPC process, find the cause of the trouble using the
following procedures if the safety circuit relay R100 turns OFF and
the process stops.
Also when the drive lamp lights except during the RPC process, the
error message IE-901 is displayed if the R100 cannot be turned
OFF. The cause of this is incorrect adjustment of the back safety
cover switch, damage to the wiring or contact point of the safety circuit
connection relay. Check to find which is the cause.